Filter
Top Products
13
OTHERSPRECAUTIONS FEATURES PREPARATION
TROUBLE-
SHOOTING
CONTENTS
BEFORE OPERATION
Push the printing unit to close.
Close the printing unit by pushing the right and left sides of the unit from the front
with both hands.
When a new paper is loaded and the printing unit is closed with the power turned
on, the paper will be automatically fed and cut.
CAUTION
When closing the printing unit, be careful not to get your hands caught
between the printer and the printing unit. Otherwise, you may get injured.
NOTE
• When closing the printing unit, push it until a click is heard.
• If the PAPER RIBBON indicator illuminates when the printing unit is closed, the
print paper may have not been installed correctly.
In this case, open the printing unit to make sure that the print paper has been
installed correctly. Then close the printing unit again.
• When the paper roll is reinstalled more than three times, the print paper may be
used up earlier than the ribbon.
Installation of the print paper and the ribbon is completed.
NOTE
• Make sure to replace the print paper and the ribbon simultaneously. A large
amount of print paper may remain depending on the used condition.
NOTE
• Empty the trim tray frequently to prevent jamming the strips at the print outlet.
Whenever you replace the paper and ribbon, make sure to throw away the
paper strips in the trim tray.
• Whenever you replace the print paper and the ribbon, clean the thermal head
and the platen roller. For the cleaning procedures, see “CLEANING” (on pages
20 and 21).