Filter
Top Products
16
PREPARATION
TROUBLE-
SHOOTING
FEATURESPRECAUTIONS OTHERS CONTENTS
ERROR MESSAGES AND COUNTERMEASURES
INDICATIONS ON THE FRONT PANEL AND COUNTERMEASURES
If, for some reason, printing is not possible or an error occurs during printing, the indicators on the front panel will
illuminate or blink. In this case, follow the procedure described below.
: Steady on : Off : Blinking
ALARM PAPER RIBBON POWER Causes and Countermeasures Page
(Orange)
This printer is in standby mode.
Connect a USB cable to the printer when not
connected.
It may take time that the printer is ready to print
images after the image data is sent.
7
15
(Green)
The printing unit is open.
• Close the printing unit.
7
(Green)
A paper jam or a problem concerning the ribbon
occurs.
• Refer to “Overcoming paper jams.”
17
(Green)
The temperature of the thermal head is too high
or too low.
• Wait until the indication goes off. When the
indicator stops blinking, the printer resumes
printing automatically.
While the printer is working, do not open the door
or turn off the power.
7
(Green)
The ribbon which is not available to this printer is
installed.
• Replace the ribbon with a new one.
The actual combination of ribbon and print paper
is inconsistent with the setting made by the
personal computer.
• Open the printing unit and conrm that the
actual combination of ribbon and print paper
is consistent with the setting made by the
personal computer. After checking, close the
printing unit.
12-13
(Green)
The print paper or ribbon is not installed.
The print paper or ribbon is used up.
• Install new print paper or ribbon.
10-13
(Green)
Other errors
19
When the ALARM or the PAPER RIBBON indicator illuminates or blinks, open the door and carry out the above
countermeasures.