Filter
Top Products
EASTMAN Fine Grain Release Positive Film 5302™ / 7302™ • H-1-5302 3
Characteristic Curves
Spectral-Sensitivity Curves
2
46810
DEVELOPMENT TIME
(Minutes)
2.8
2.6
2.4
2.2
2.0
0.00
0.10
GAMMA
NET
FOG
Time-
Gamma
Time-Fog
2 min.
3 1/2 min.
5 min.
7 min.
9 min.
Visual
F010_0023AC
D-97, at 21 C (70 F)
3.0
Characteristic
Curves
Diffuse
Tungsten
KOKAK Developer
Process:
Exposure:
Densitometry:
2.01.0
4.0
3.0
2.0
1.0
DENSITY
0.0
0.0
1.0
LOG EXPOSURE (lux-seconds)
3.0
3.2
3.4
700 750650600550500450400350300250
*Sensitivity = reciprocal of exposure (ergs/cm ) required
to produce specified density
WAVELENGTH (nm)
2
LOG SENSITIVITY
3.0
*
2.0
1.0
0.0
1.0
Process:
Effective Exposure:
KODAK Developer
Densitometry:
y
F010_0024AC
_
_
_
D-97 at 21 C(70 F) to
1.4 seconds
recommended control
gamma
D=0.3 Above
gross fog
D=1.0 Above
gross fog
Diffuse Visual
Modulation-Transfer Curve
Notice: While the data presented are typical of production
coatings, they do not represent standards which must be met
by Kodak. Varying storage, exposure, and processing
conditions willaffect results. The companyreserves the right
to change and improve product characteristics at any time.
These photographic modulation-transfer values were
determined by using a method similar to the one described in
ANSI Standard PH2.39-1977(R1990). The film was
exposed with the specified illuminant to spatially varying
sinusoidal test patterns having an aerial image modulation of
a nominal 35 percent at the image plane, with processing as
indicated. In most cases, the photographic modulation-
transfer values are influenced by development-adjacency
effects and are not equivalent to the true optical modulation-
transfer curve of the emulsion layer in the particular
photographic product.
1001 2 3 4 5 10 20 50 200 600
SPATIAL FREQUENCY (cycle/mm)
RESPONSE (%)
10
1
2
5
3
7
30
20
100
70
50
200
Diffuse Visual
gamma
recommended control
1.4 seconds
D-97 at 21 C(70 F) to
Densitometry:
KODAK Developer
Effective Exposure:
Process:
F010_0025AC