Filter
Top Products
A-61514 September 2004 21
Maintenance
Cleaning the scanner The scanner will collect dust and other debris during routine scanning.
For optimal scanner performance, follow the detailed cleaning instructions
in this section and clean the feed module rollers, separator module rollers,
imaging guides, transport area, and paper path at least once per week.
Clean the scanner and paper path daily if you are scanning carbonless
paper or newsprint.
Use only these cleaning materials:
IMPORTANT: Staticide Wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the Material Data Safety Sheet (MSDS) for more information.
The MSDS is available on the Kodak web site at
www.kodak.com/go/MSDS.
The roller cleaning pad contains sodium lauryl ether sulfate and
sodium silicate which can cause eye irritation. Refer to the
MSDS for more information.
Allow all rollers to dry completely before using the scanner.
Use only non-flammable cleans such as those provided through
Kodak Parts Services.
Do not use cleaners in confined areas, use with adequate
ventilation.
Do not use cleaners on hot surfaces. Allow surfaces to cool to
ambient temperature before use.
NOTES: The use of any other cleaning materials could damage your scanner.
Use fresh cleaning material unless otherwise indicated.
In addition to the recommended cleaning supplies, you may use a
vacuum cleaner to remove debris from the scanner.
Some debris from the rubber tires on the feed module and separator
module is normal. Tire debris does not always mean that the tires
are worn or damaged. After cleaning, inspect the tires for wear and
replace the separator module or feed module if necessary.
To order cleaning supplies, refer to Appendix B, Supplies
and Accessories.
Item CAT No.
Kodak Digital Science Roller Cleaning Pads (24) 853 5981
Staticide Wipes for Kodak Scanners (144) 896 5519
Kodak Digital Science Transport Cleaning Sheets (50) 169 0783