Filter
Top Products
Getting help
www.kodak.com/go/support
41
Picture quality problems
Status Solution
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens (see page 46).
■ Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash (see page 7) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 44.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Smart Capture mode, adjust the Exposure Compensation (see
page 24).
Picture is too light ■ Reposition the camera to reduce the amount of available light.
■ Turn the flash off (see page 7).
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 44.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Smart Capture mode, adjust the Exposure Compensation (see
page 24).