Kodak CX7300 Digital Camera User Manual


 
Troubleshooting
35
Camera ready light status
Camera error #XXXX.
See user’s guide.
An error is detected. Turn the Mode dial off, then back
on. If the message reappears,
contact Customer Support
(page 36).
Status Cause Solution
Ready light does not
turn on and the
camera does not
work.
Camera is not turned on. Turn on the camera (page 4).
Batteries are exhausted
or are not charged.
Install new batteries (page 2) or
charge rechargeable batteries.
Mode dial was on when
batteries were reloaded.
Turn Mode dial off, then back on.
Ready light blinks
green.
Picture is being
processed and saved to
the camera.
Camera is operating normally.
Ready light blinks
amber.
Flash is not charged. Wait. Resume picture taking when
the light stops blinking and turns
green.
Camera is initializing.
Ready light blinks red
and camera turns off.
Batteries are low or
exhausted.
Install new batteries (page 2) or
charge rechargeable batteries.
Ready light glows
steady red.
Camera’s internal
memory or card is full.
Transfer pictures to the computer
(page 27), delete pictures from the
camera (page 17), switch image
storage locations (page 12), or insert
a card with available memory
(page 7).
Camera processing
memory is full.
Wait. Resume picture taking when
the light turns green.
Card is read-only. Change the image storage location
to internal memory (page 12), or use
a different card.
Ready light glows
steady green.
Camera is on; ready to
take a picture or video.
Camera is operating normally.
Message Cause Solution