Filter
Top Products
Troubleshooting
www.kodak.com/go/support
43
Flash does not fire ■ Check the flash setting and change as needed (page 26).
NOTE: The flash does not fire in all modes.
Storage location is
almost or entirely full
■ Transfer pictures to the computer (page 16).
■ Delete pictures from the card or insert a new one (page 13).
■ Change image storage location to internal memory (page 31).
Battery life is short
■ Make sure the correct battery type is loaded (page 1).
■ Wipe the contacts with a clean, dry cloth (page 57) before inserting
a battery in the camera.
■ Insert a new or charged battery (page 1).
You cannot take a
picture
■ Turn the camera off, then on again. Make sure the camera is not in
Favorites mode.
■ Depress shutter button completely down (page 4).
■ Insert a new or charged battery (page 1).
■ Wait until the Ready light glows green before attempting to take
another picture.
■ Memory full. Transfer pictures to the computer (page 16), delete
pictures from the camera (page 13), change image storage
location, or insert a new card.
Error message
appears on LCD
screen
■ Turn the camera off.
■ Remove memory card from the camera.
■ Remove the battery and wipe the contacts with a clean, dry cloth
(page 57).
■ Insert a new or charged battery (page 1).
■ Turn on the camera.
■ If all else fails, get customer support help (page 48).
Memory card not
recognized or camera
freezes with card.
■ Card may be corrupted. Format card in camera (page 33).
■ Use another memory card.
If... Try one or more of the following