Filter
Top Products
Troubleshooting
www.kodak.com/go/support
45
Pictures remaining
number does not
decrease after taking
a picture
■ Continue taking pictures. The camera is operating normally.
(The camera estimates the number of pictures remaining after each
picture is taken, based on picture size and content.)
Flash does not fire ■ Check the flash setting and change as needed (page 20).
NOTE: The flash does not fire in all modes.
Storage location is
almost or entirely full
■ Transfer pictures to the computer (page 14). Delete pictures from
the card (page 12) or insert a new card.
■ Change image storage location to internal memory (page 31).
Battery life is short ■ Make sure the correct battery type is installed (page 2).
■ Wipe the contacts with a clean, dry cloth before inserting a battery
in the camera.
■ Insert a new or charged battery.
You cannot take a
picture
■ Turn the camera off, then on again. Make sure the camera is not in
Favorites mode.
■ Depress shutter button all the way (page 6).
■ Insert a new or charged battery (page 2).
■ Wait until the Ready light turns green before attempting to take
another picture.
■ Memory full. Transfer pictures to the computer (page 14), delete
pictures (page 12), change image storage location (page 31), or
insert another card.
Error message
appears on LCD
■ Turn the camera off, then on again.
■ Remove memory card from the camera.
■ Remove the battery and wipe the contacts with a clean, dry cloth.
■ Insert a new or charged battery (page 2).
■ If problem still exists, get help (page 49).
Status Solution