Filter
Top Products
46 www.kodak.com/go/support
Troubleshooting
Direct printing (PICTBRIDGE enabled printer) problems
Picture quality problems
Status Solution
Cannot print to a
PICTBRIDGE Printer
■ In the Setup menu, change the Computer Connection setting to
Other Application (see page 39).
Status Solution
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens (see page 50).
■ Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject (see page 36).
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■ Use a larger picture size (see page 34).
■ If you’re manually adjusting the ISO speed, realize that high ISO
setting may cause grainy pictures (see page 35).
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash (see page 12) in Program mode, Backlight in SCN
mode, or change your position so light is not behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See Specifications, page 48.)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ In Program mode, increase the Exposure Compensation (see
page 35).