Filter
Top Products
When using the movie-recording drive
mode, the 4X digital zoom is active even
when the 2X zoom is set.
When the digital zoom
is active, the wide
focus frame and spot
focus area (p.50) are
enlarged.
41
40
RECORDING MODE
Auto reset Digital zoom
Assisting the optical zoom is a 2X and 4X digital zoom. The digital zoom is activated in
the custom section of the recording-mode menu (p. 28).
The digital zoom increases the magnification of the greatest telephoto setting of the
optical zoom in 0.2 steps up to 2X or 4X. Although the images recorded with the digital
zoom are interpolated to the set image size, the quality of the images may not be equal
to images taken without the digital zoom; the greater the power of the digital zoom the
lower the image quality. The effect of the digital zoom is visible on the LCD monitor
only. The digital-zoom function is canceled if the LCD monitor is turned off (p. 52).
At the maximum telephoto position, press
the zoom lever up to engage the digital
zoom.
• The zoom magnification will be displayed in
the top right corner of the monitor.
• To zoom out, press the zoom lever down.
Activate the digital zoom in the custom
section of the recording mode menu.
• The digital zoom will remain active until
reset on the menu.
*The flash mode is reset to autoflash with red eye reduction if autoflash with red eye
reduction was last set, if not the mode will be reset to autoflash. See page 26 for
information on flash modes.
Auto reset is initially active. To prevent the camera resetting, this function can be turned
off in the basic section of the menu. However, the camera will reset it the battery is
removed for an extended period. An internal battery will protect the clock, calender, and
camera settings for more than 24 hours if the camera is used for at least 5 minutes
before the battery is removed.
Exposure compensation will be disabled when the auto reset function is active and any
previous exposure-compensation setting is canceled.
Wide focus frame
Spot focus area
Flash mode*
Drive mode
White balance
Camera sensitivity
LCD monitor
Spot focus area
Function
Auto
Single-frame advance
Auto
Auto
Full display
Wide focus frame
Reset to
When auto reset is active, the following functions return to their program setting when
the camera is turned off:
26
30
38
44
52
50
Page