Filter
Top Products
82 83
DATA
-TRANSFER MODE
Confirm the indicator lamp is not lit and then drag the mass-storage device icon and
drop it into the trash.
Disconnect the USB cable and turn off the camera.
• If the USB cable is disconnected before performing the first step, an alert message will
appear. Always complete the first step before disconnecting the USB cable.
Macintosh
When more than one external device are connected to the computer, repeat the proce-
dure above except right click on the unplug-or-eject-hardware icon. This will open the
unplug-or-eject-hardware window after clicking on the small window indicating the
unplug-or-eject-hardware routine.
Click on the small window to stop
the device. The safe-to-remove-
hardware window will open. Turn
off the camera and then discon-
nect the USB cable.
Disconnecting the camera from a computer
Windows Me, 2000 professional, and XP
Confirm the indicator lamp is not lit.
Turn off the camera and then dis-
connect the USB cable.
To disconnect the camera, click once on the unplug-or-eject-hardware icon
located on the task bar. A small window will open indicating the device to
be stopped.
Windows 98 and 98SE
Never remove the
USB cable while the
viewfinder indicator
lamp is lit!
The hardware devices to be stopped will be
displayed. Highlight the device by clicking on
it then click “Stop.”
A confirmation screen will appear to
indicate the devices to be stopped.
Clicking “OK” will stop the device.
A third and final screen will appear
to indicate the camera can be safe-
ly disconnected from the computer;
click OK. Turn the mode dial to
another position and then discon-
nect the USB cable.