Filter
Top Products
Firmware Update 2.3.0.0 / 3
Step 3:
Copy the rmware to a CF or SD memory card
Preparing the card (formatting):
1. Format the memory card in the camera. Information about
formatting the memory card can be found in the camera
manual.
Important:
When you format the memory card, all the data on it –
including protected les – will be deleted and cannot be
recovered without the use of specialist software.
2. Insert the formatted memory card into the relevant card
slot on your PC, or use an external card reader.
3. Copy the le S_006_2_3_0_0.FW to the master directory
(*1) on the memory card.
(1) Master directory = Top level of memory card - do not copy to one of the
folders.
Step 4:
Install the rmware update
1. Remove the card properly from your card reader, insert the
card into the camera and close the bottom cover.
2. Press and hold the joystick on the rear of the camera and
turn on the camera. The update process starts after a few
seconds. You can now release the joystick. The update
process is shown as a graphic in the monitor and may take
several minutes.
3. When the installation has been completed successfully,
turn o the camera. When you turn it on again, the latest
rmware is active and can be checked in the menu (see
Step 1).
Note:
If the battery does not have sucient charge, a corresponding
warning message appears in the monitor on the camera.