Filter
Top Products
1. Remove the three security screws (use included security bit wrench) from the bottom of the iCAM.
2. While gently pulling the cover upward, pull forward simultaneously.
3. Unscrew the installation plate screw and slide the body of iCAM4100 upward to separate from the installation
plate.
4. Position the installation plate on the desired wall near the secured door and mark the holes as the figure below
illustrates. The recommended height from the floor to bottom of unit is 140cm (55”), however installation height
can be adjusted depending on average height of users.
5. In case of recessed mounting, leave 6mm (1/4”) of extra space above the marked hole when mounting the
installation plate to allow the iCAM to slide down onto the installation plate tabs.
4
iCAM4100 Installation
Front
Back
1
2
Screw to fix the plate