Filter
Top Products
30
Motion Detector Setting (MOTION DET)
This camera has an alarm function. When the picture changes, the
internal switch is closed.
• Sensitivity
Motion is detected when the accumulated value of changed
brightness level exceeds 10% (MEDIUM mode) of reference in
more than one area.
• Condition
The alarm function performs after 10 seconds when the camera is
turned on.
• Caution
Motion detection malfunctions under the following situations.
Please note the conditions below.
- If shooting an object under flickering fluorescent.
- If leaves or curtains are swayed by the wind.
• Alarm keep low for 1 second after the end of moving picture.
• This function which is Motion Detection & Sensitivity has not
been evaluated by UL.
LEFT CENTER
TOP
BOTTOM
RIGHT
1/3
4/15
7/15
4/15
1/3 1/3
0
OPEN
OPEN
CLOSE
Vcc
Alarm
Out
Detection Area
1. The period of motion.
2. The hold time is 1 sec.
LVC-SX703PC_AA4HEL_ENG_MFL-129 11/7/06 12:05 PM Page 30