Filter
Top Products
14
Bluefin Monitor - Bulkhead Installation
1) Remove the Rear Plate.
2) Using a flat head screwdriver or coin, remove the Port Plug. (Refer Fig. 16)
3) On the inside of the Rear Plate, remove the four screws using a 3/32 allen key and
remove circuit board. (Refer Fig. 17)
4) Feed Bulk Head cable through Bulk Head port. (Refer Fig. 18)
5) Insert Bulk Head into Rear Plate until it is firmly seated.
6) Tightening bulk head by turning the bulk head itself with a 3/4” wrench.
7) Attach Bulk Head Cable into the Primary Bulkhead connector on the inside of the
Rear Plate circuit board. (Refer Fig. 19)
8) Replace circuit board and secure it to the Rear Plate using the four button head cap
screws.
(Fig. 16)
(Fig. 17)
Button head cap screws
(Fig. 18)
(Fig. 19)
Attaching the Remote or Compact Monitor
1. Attach clamp assembly to back of monitor.
2. Attach monitor/clamp assembly to quick connect post by pressing down and
rotating until black sleeve locks into position.
3. Adjust monitor by releasing clamp assembly (clockwise to tighten, counter
clockwise to loosen).
4. Cable plugs are identical at each end. Attach by aligning the pins and pressing into
the bulkhead until the black rubber seats.Turn locking sleeve clockwise to tighten.