Filter
Top Products
Operating Your Camera
32
Day&Night Color CCD Camera
33
Day&Night Color CCD Camera
Operating Your Camera
Color B/W Point : 1~5
1 : around 1 LUX
3 : around 3~4 LUX
5 : around 7~8 LUX
The color changing point above is based on the AGC level to the middle.
You should select the proper value depending on the condition like lens.
Color B/W Time : 1sec.~10sec.(1sec. term)
B/W Color Time : 2sec.~20sec.(1sec. term)
BURST : OFF/ON
EXT : The Color/ BW mode change can be controlled by an external Sensor or
other equipment connected on the DN terminal (D/N IN) on the back side
of camera.
Pressing the SET button at EXT mode, you can control the burst existence
during the mode changing to B/W mode.
BURST : OFF/ON
DN input terminal is pull-up of DC 5V and over 0.2mA.
Open contact : Color mode
Closed contact : B/W mode
Synchronization Mode
Two synchronization modes are available internal and External linelock. In
linelock mode, it synchronizes the video signal between cameras without a
synchronous generator. The linelock synchronization is only used in the areas of
60Hz(NTSC models)/50Hz(PAL models)
1. Press the SET button to display the setup menu and move the arrow indicator
to 'Sync.' Using the UP or DOWN button.
Change the value using the
LEFT or RIGHT button(1~5)
Change the value using the
LEFT or RIGHT button(1~10)
Change the value using the
LEFT or RIGHT button(2~20)
Color
B/W Change
Color B/W Point 3
Color B/W Time 5
B/W Color Time 10
BURST OFF
Press SET to Return
I
I
1.Under Gain OFF Color/BW does not change over automatically, ON/OFF is only available.
2.If you change ‘Gain’ menu OFF to AGC, ‘Color’ mode change to AUTO automatically.
3.Adjust the focus if the camera is out of focus for changing modes.
When the power frequency is 60Hz, you can use linelock mode(NTSC models).
When the power frequency is 50Hz, you can use linelock mode(PAL models).
Select ‘L/L’ or ‘INT’ using the
LEFT or RIGHT button.
Setup
Camera ID
BLC
Lens
Shutter
Gain
White Balance
Motion Detect
Color
Sync.
Reset
End
OFF
OFF
DC
OFF
AGC
ATW
OFF
AUTO
L / L
Adjust the Phase level using
the LEFT or RIGHT.
button(from 0 to 270°)
Phase 45
Press SET to Return
Press SET button
I