Filter
Top Products
6. Bounced flash
33
6.1 Bounced flash in automatic flash mode
It is advisable to check prior to the actual exposure
whether the light is sufficient for the selected aperture
.
Please refer to chapter 9 „Correct exposure indicati-
on“ for the corresponding procedure.
6.2 Bounced flash in manual flash mode
The required camera aperture in the manual flash
mode is best established with an exposure meter. If
an exposure meter is not available observe the follo-
wing rule of thumb:
Camera aperture =
guide number
lighting distance x 2
to establish the f-stop. For added certainty two extra
exposures
should be shot, one with +1 f-stop and one
with -1 f-stop.
This rule of thumb only applies to rooms
with a normal ceiling height.
The
guide number
for the given film speed can be
selected from the table in Chapter 12 „Technical
Data“.
The
lighting distance
is the distance between the
camera and the subject.
Tilting the reflector:
Hold the mecablitz with one hand and use the other
hand to pull the reflector head forward, out of the
casing, until the stop point is reached.You can then tilt
the reflector vertically upward by about 80°.
ķ