Metz 60 CT-1 Camera Flash User Manual


 
33
ķ
10. Care and Maintenance
Remove dust and grime with a soft dry cloth, or a silicon-treated cloth. Do
not use detergents as these may damage the plastic parts.
Forming the flash capacitor
The flash capacitor incorporated in the flashgun undergoes a physical chan-
ge when the flashgun is not switched on for prolonged periods. For this rea-
son it is necessary to switch on the flashgun for approx. 10 minutes every 3
months. The battery must supply sufficient power to light up the flash-ready
light within one minute after the flashgun was switched on.
11. Technical Data
Guide numbers at ISO 100/21°:
In the metric system: 60 In the imperial system: 197
6 auto apertures at ISO 100/21°:
2 - 2,8 - 4 - 5,6 - 8 - 11
Flash durations:
• approx. 1/200 . . . 1/20.000 sec.
• in M mode approx. 1/200 sec. at full light output.
• in winder mode approx. 1/3500 sec.
• in motordrive mode approx. 1/5000 sec.
Coverage angle of sensor
: approx. 25°
Colour temperature: approx.
: ca. 5600 K
Film speed:
ISO 25 to ISO 3200
Synchronisation
: low-voltage thyristor ignition
Number of flashes
:
160* . . .4500 . * at full light output
Recycling time:
5 Sek. (in M mode) . . . 0,25 Sek.
Swivelling ranges and locking positions of flash head:
upwards: 15° 30° 45° 60° 75° 90°
counter-clockwise 90° 180°
clockwise 90° 180°
Dimensions
approx. in mm (wxhxd)
Flash unit 110 x 254 x 102
Generator126 x 165 x 58
W
eight:
Flash unit approx. 650 g
Generator with 60-38 battery approx. 1850 g
Table 1: Guide numbers at maximum light output (page 51)
Table 2: Chargers (page 51)
Included:
Flash unit, bracket, 60-38 battery, generator, connecting cable, charger,
synch cable 60-50, operating instructions.