Filter
Top Products
222
n
—
●
(blinks)
Camera can not focus using autofocus.
Change
composition or focus manually.
31,
55, 60
Subject is too bright. q
• Use a lower ISO sensitivity 74
• Use commercial ND filter —
• In mode:
S Increase shutter speed 82
A Choose a smaller aperture (larger f-number) 83
Subject is too dark. r
• Use a higher ISO sensitivity 74
• Use flash 70
• In mode:
S Lower shutter speed 82
A Choose a larger aperture (smaller f-number) 83
No Bulb in S mode.
A
(blinks)
Change shutter speed or select manual exposure
mode.
82, 84
&
(blinks)
Interval timer shooting —
Menus and playback not available during interval
timer shooting.
To end interval timer shooting,
turn camera off.
—
—
N
(blinks)
Flash has fired at full power.
Check photo in
monitor; if underexposed, adjust settings and try
again.
—
Flash is in TTL mode. Choose
another setting or use a CPU
lens.
Change flash mode setting on optional flash unit
or use CPU lens.
194
—
N/s
(blinks)
• Use the flash. 70
• Change distance to subject, aperture, flash
range, or ISO sensitivity.
73,
74, 83
• Optional SB-400 flash unit attached: flash is in
bounce position or focus distance is very short.
Continue shooting; if necessary, increase focus
distance to prevent shadows from appearing in
photograph.
—
Flash error
Error occurred updating firmware for optional
flash unit. Contact Nikon-authorized service
representative.
—
Eye-Fi upload could not be
disabled.
The card is still transmitting
and pictures may be
uploaded.
—
The Eye-Fi card is still transmitting data after
Disable has been selected for Eye-Fi upload.
To
terminate wireless transmission, turn the camera
off and remove the card.
173
Indicator
Solution 0Monitor Viewfinder