Nikon 5000ED Photo Scanner User Manual


 
5
Precautions for Use
Precautions for Use
Observe the following precautions to ensure that the scanner always produces the best pos-
sible results.
Check the status LED
•Do not turn the scanner off or insert or remove fi lm or adapters while the status LED is blinking.
•Do not use other USB devices or turn them on or off while the status LED is blinking.
•Do not connect or disconnect USB or IEEE 1394 (Firewire) cables while the status LED is blinking.
Do not operate camera control software for digital cameras connected via USB while the status LED is
blinking.
When the scanner is not in use
•To prevent accumulation of dirt and dust when the device is not in use, turn the scanner off and insert
one of the supplied adapters in the adapter slot.
•Remove optional holders from the adapter slot when not in use.
Connecting the scanner
Connect the scanner directly to the computer. The scanner may not function as expected when con-
nected to a USB hub or keyboard.
The scanner may not function as expected when used together with other USB devices. Should the
scanner not function as expected, use the scanner with all other USB devices disconnected.
•Do not connect two or more scanners to the computer simultaneously.
Protecting fi lm
Before inserting fi lm, remove dirt and dust with a blower. This will not only keep the fi lm free of
scratches but will also help prevent scanning errors and malfunctions.
•Remove fi ngerprints with a soft, dry cloth, being careful not to scratch the fi lm.
•Remove fi lm from adapters or holders after scanning. Storing fi lm in an adapter or holder could dam-
age the fi lm.
•The fi lm base and emulsion will deteriorate if exposed to high temperatures or humidity. Be sure tem-
perature and humidity are within the limits given below.
Sudden changes in temperature and humidity, even when within the limits stated below, can cause
condensation on the fi lm. Check before use to ensure that no condensation is present. If condensa-
tion has occurred, leave the fi lm out until it dries. Condensation can damage the fi lm during inser-
tion.
•The operating environment for the scanner is as follows:
Temperature: +10 – +35 °C (+50 – +95 °F)
Humidity: 20 – 60%