Filter
Top Products
18
Jp
Kr
De
It
Cz
Sk
Ck
Ch
Nl
Ru
Sv
Es
En
Fr
■ Vibration reduction mode (VRII)
Setting the vibration reduction ON/OFF switch
ON: The effects of camera shake are reduced while the
shutter- release button is pressed halfway and also
at the instant the shutter is released. Because
vibration is reduced in the viewfinder, auto/
manual focusing and exact framing of the subject
are easier.
OFF: The effects of camera shake are not reduced.
Notes on using vibration reduction
• By enabling vibration reduction (VR), slower shutter speeds
(approximately four stops*) can be used when shooting distance is
between and 2.6 m (the reproduction ratio from to 1/30×). The
higher the reproduction ratio from 1/30× is, the more the effects of
vibration reduction will decrease gradually. (*Based on results achieved
under Nikon measurement conditions. The effects of vibration
reduction may vary according to shooting conditions and use.)
• After pressing the shutter-release button halfway, wait until the image
in the viewfinder stabilizes before pressing the shutter-release button
the rest of the way down.
• Due to the characteristics of the vibration reduction mechanism, the
image in the viewfinder may be blurred after the shutter is released.
This is not a malfunction.
• If the camera is panned in a wide arc, compensation for camera shake
in the panning direction is not performed. For example, only the effects
of vertical camera shake is reduced with horizontal panning.
• Do not turn the camera off or remove the lens from the camera while
vibration reduction is operating. Failure to observe this note could
result in the lens sounding and feeling as if an internal component is
loose or broken when it is shaken. This is not a malfunction. Turn the
camera on again to correct this.
• With cameras featuring a built-in flash, vibration reduction does not
function while the built-in flash is charging.
• With autofocus cameras featuring an AF-ON button, vibration
reduction does not function even when the AF-ON button is pressed.
• When the camera is mounted on a tripod, set the vibration reduction
ON/OFF switch a to OFF. However, set the switch to ON when using
a tripod without securing the tripod head, or when using a monopod.
ON
OFF