21
t
Standby function to conserve battery power
If the SB-600 and camera are not being used, the standby function will
automatically activate after 40 seconds, switching the SB-600 to standby mode
to conserve battery power.
• In the standby mode, the
R
indicator appears on the LCD panel.
• When used with a camera body that is compatible with the TTL auto flash mode (p. 8),
the SB-600 will automatically turn off after the camera’s exposure meter is switched off.
• When in standby mode, the SB-600 turns back on again when its
b
or
h
button is
pressed or the shutter release button is lightly pressed (when using a camera body that
is compatible with the TTL auto flash mode) (p. 8).
• The standby function does not work in the wireless flash mode, regardless of the
SB-600’s setting, when the Speedlight is used as a remote flash unit (p. 57).
• If, due to battery exhaustion, the ready-light does not come on within 60 seconds of
turning on the power or after the flash has fired, the following indicator appears on the
LCD panel and the SB-600 enters standby mode regardless of its setting. In this case,
replace or recharge your batteries.
•To avoid accidental firing or a malfunction when carrying the SB-600 in your camera
bag, press the
b
button to turn off the flash unit, and make sure the
R
indicator disappears.
Setting the standby function
Set the standby function in the Custom Settings mode (p. 52).
Basic operation