Filter
Top Products
64
Flash shooting in Advanced Wireless Lighting
7
Confirm that all the ready-lights of the master and
remote flash units are on, then press the
h
button on the master flash unit to test fire the units.
• The master flash unit fires first, then the remote flash
units in group A fire, followed by those in group B.
• If a certain remote flash unit does not fire, change the
setup by moving the remote unit closer to the subject
or redirect its light sensor window toward the master
flash unit, then test fire the new setup.
•You can check the illumination before actually taking
pictures using the Modeling illuminator (p. 45).
8
Finally confirm the aperture and flash shooting
distance just as in TTL flash shooting, then shoot.
• Refer to page 17 for TTL flash shooting.
• Flash operation can be confirmed by the ready-light
or the beeping sound (p. 65).
t
Modeling illuminator in the Advanced Wireless Lighting mode
When the Modeling illuminator button of the master flash unit (featuring CLS) is
pressed, the Modeling illuminator of all remote flash units set on the Master
flash unit will fire. Further, when the compatible camera’s Modeling illuminator
button is pressed, the Modeling illuminator of the master flash unit and all other
remote flash units fire.
• The Modeling illuminator function operates for 1 second.
• Both the master and remote flash units fire at the flash output level
compensation value as set.
• Refer to your compatible camera instruction manual for details on the
camera’s Modeling illuminator.