Filter
Top Products
Tutorial: “Point-and-Shoot” Photography ( Mode) 17
5
Turn the camera off when shooting is complete.
The Shutter-Release Button
The camera has a two-stage shutter-release button. The camera focuses and the monitor turns off
when the shutter-release button is pressed halfway. If the subject is stationary (or if single-servo auto-
focus is selected in P, S, A, or M mode; 23), a beep will sound and focus will lock. To take the photo-
graph, press the shutter-release button the rest of the way down.
Focus Take photograph
The Built-in Flash
If additional lighting is required for correct exposure in mode, the
built-in flash will pop up automatically when the shutter-release button is
pressed halfway (to prevent the flash from firing when lighting is poor,
select Auto (flash off) mode). Flash range varies with aperture and ISO
sensitivity ( 117); remove lens hoods when using the flash. If the flash is
required, photographs can only be taken when the flash-ready indicator
( ) is displayed. If a photograph can not be taken and the flash-ready
indicator is not displayed, remove your finger briefly from the shutter-
release button and try again.
To save battery power when the flash is not in use, return it to its closed
position by pressing it gently downward till the latch clicks into place. For
more information on using the flash, see page 34.
4.2 Smoothly press the shutter-release button the rest of the
way down to release the shutter and record the photo-
graph. The access lamp next to the memory card slot
cover will light. Do not eject the memory card or remove or
disconnect the power source until the lamp has gone out and
recording is complete.