North Star S510 Digital Camera User Manual


 
124
Technical Notes
Troubleshooting
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem Cause/Solution A
Monitor is blank Camera is off.
Battery is exhausted.
Standby mode for saving power: press the
shutter-release button halfway.
When flash lamp blinks red, wait until flash
has charged.
Camera and computer are connected via USB
cable.
Camera and TV are connected via AV cable.
Time lapse or interval timer photography in
progress.
20
20
21, 25
29
69
67
Monitor is hard to read Adjust monitor brightness.
Monitor is dirty. Clean monitor.
Monitor has dimmed to save power. Monitor
brightens when controls are used.
104
119
21
Camera turns off without
warning
Battery is low.
Camera has turned off automatically to save
power.
Battery is cold.
20
109
118
Date and time of recording are
not correct
Pictures recorded before clock was set, and
“Date not set” indicator blinks during shooting,
will have time stamp of “00/00/0000 00:00”;
movies and voice recordings will be dated “01/
09/2007 00:00.”
Check camera clock regularly against more
accurate timepieces and reset as required.
16
101
No indicators displayed in
monitor
[Hide info] is selected for [Photo info].
Select [Show info].
104
[Date imprint] not available Camera clock has not been set. 16,
101
Date not appearing on pictures
even when [Date imprint] is
enabled
Date does not appear on movies or on pictures
taken using
,,
dlp or when [Continuous] is
set to [Continuous] or [BSS].
35, 38,
40, 55,
86
Camera settings reset Backup battery is exhausted; all settings were
restored to their default values.
102