Filter
Top Products
E-20E-19
Load the digital camera.
Open the Case.
Insert the buckle opener of the accessory into the buckle opening
lever as shown in the figure (in direction ) Pull the buckle opener
slowly (in direction ). When not using the buckle opener, hold the
buckle opening lever with your thumb and index finger from the side
and pull it up slowly.
Make sure that the digital camera
is turned OFF. Align the projecting
part of the camera's zoom lever
with the notch on the case's zoom,
then insert the camera gently into
the case.
: • Confirm that the projecting part of the zoom lever of
the digital camera is set securely to the zoom lever
notch on the inside of the Case. When the setting is
not secure, the loading of the digital camera is not
complete and closing of the rear lid of the Case may
not be possible or zoom may not function even when
the zoom lever is operated.
• Insufficient sealing will cause water leakage.
CAUTION
3. Install the digital camera.
Check the digital camera.
Check the digital camera before loading it in the Case.
Battery Confirmation
Since the LCD monitor is used for picture confirmation while taking
pictures under water, the battery life becomes short.
Confirm that the remaining battery capacity is sufficient.
Confirmation of the Remaining Number of Pictures to be Taken
Confirm that the image storage has a sufficient remaining number
of pictures to be taken.
Removing the carrying strap and lens cap from the digital camera
If the digital camera has a carrying strap and lens cap attached, be
sure to remove them before inserting the digital camera into the
case.
Note:• To make sure you aren't prevented from shooting because the
battery runs out, it is recommended that you load a fully-
charged battery before every diving session.
Removing the filter from the digital camera
If the digital camera has a lens filter attached, be sure to remove it
before inserting the camera into the case.
: • If the digital camera is inserted into the case without
removing the carrying strap and lens cap, the case
cannot be closed properly and water penetration may
result.
• Be careful when removing the carrying strap and lens
cap from the digital camera. Olympus will not assume
any liability for any damage that may result from
dropping the camera.
CAUTION
: • The digital camera cannot be inserted in the case if a
filter is attached to the camera lens. Always be sure
to remove the lens filter.
CAUTION
Loading in the Case
Which digital cameras can be loaded?
This product PT-020 is exclusively used for the CAMEDIA C-5060
Wide Zoom.
Check the operation of the camera.
Confirm the operation according to the instruction manual for the
digital camera.