Filter
Top Products
E-16E-15
Removing the hot shoe cable cap
To perform TTL flash shooting when this case is used, connect the
hot shoe cable provided with the optional PFL-01 between the
connector on this case and the C-5060 Wide Zoom's hot shoe.
1
Turn the hot shoe cable connector cap inside
the case counterclockwise to remove it.
2
Insert the connector of the hot shoe cable into
the case's connector and turn the connector
screws all the way clockwise to connect them
firmly.
3
Insert the cable's hot shoe into the C-5060
Wide Zoom's hot shoe.
4
When not using the hot shoe cable, attach the
hot shoe cable cap to the hot shoe cable
connector inside the case and turn the cap all
the way clockwise to attach it firmly.
: •
If the TTL cable connector cap is loose, water
penetration may result. Be sure to turn the cap all the
way clockwise to make sure that it is attached tightly.
CAUTION
❈ Refer to the optional PFL-01's instruction manual for detailed
instructions on using the TTL cable and hot shoe cable.
Removing the TLL cable connector cap
TTL flash shooting by combining this case (PT-020) and the case for
FL-20 flash (optional PFL-01):
---- How to attach the TTL cable connector cap to the case ----
Make sure there is no foreign matter attached to the O-rings inside
the cap and on the TTL cable connector. Attach the cap and turn it all
the way clockwise until it is on securely.
TTL cable
connector cap
Turn counter clockwise.
Remove.
Underwater
TTL cable
Insert into the
connector.
Turn the connector screw all the way
clockwise to secure the connection.
Turn the cap clockwise
as far as it goes.
Put the cap on the case.
1
2
1
Remove the TTL cable connector
cap from this case.
2
Connect the underwater TTL
cable connector, provided with
the PFL-01, to the TTL cable
connector on this case.
: •
Be sure to remove the camera from the case when
inserting the connector of the hot shoe cable into the
case’s connector.
CAUTION