Oregon ATC-2K Digital Camera User Manual


 
I) Camera Precautions
Notice the following guidelines when using your camera
• ATC-2K is not shock-proof. You should avoid dropping it.
• For your safety, do not press the buttons on the camera during sports activities.
• Do not place the camera in a damp or dusty location for extended periods of time. This may
cause a fire or an electrical shock.
• Do not leave the camera in places exposed to extremely high temperatures, such as under direct
sunlight for extended periods of time. This may affect the camera housing and internal components.
• Clean the lens with a blower (typically a small device with a rubber bulb attached to one end that
you pump to produce a stream of air out the other end), or wipe it with a soft cloth in a spiraling
motion to remove fingerprints or dust.
• We recommend using Alkaline batteries in temperatures between 32° F to 104° F (0°C to 40°C).
• The working temperature range of a normal Alkaline AA battery is 32° F to 104° F (0°C to 40°C).
Above or below this temperature may cause the batteries to malfunction. We recommend using
Lithium batteries in temperatures below 32° F (0°C).
• Turn off the camera before removing the batteries and the memory card. The card and the data
may be damaged if the memory card is inserted or removed while the camera is still on.
• Remove the batteries and memory card before storing the camera for long periods of time, then
keep it in a well-ventilated place to prevent mould.
• Under the following circumstances, have the camera repaired by qualified personnel:
a) The plug is damaged or worn.
b) The device has been dropped and/or the housing has been damaged.
c) Liquid has entered the camera.
Disclaimer: Oregon Scientific will not, under any circumstances, be responsible for injuries or
property damages incurred during participation of any high-risk sport/activity not endorsed or
recommended by Oregon Scientific. Should the camera malfunction under these circumstances, it
would not be covered by the warranty. The warranty will cover manufacturing defects.
Notes on copyright: Users are asked to note that the transfer of memory containing photos or
data protected under copyright laws is only permissible within the restrictions imposed. Users
assume all responsibility in the event that copyrights are violated by the use of this camera.
1
2
Waterproof Feature
This ATC-2K camera is waterproof up to 3m. Oregon Scientific will not assume any
responsibility for malfunction of the camera caused by water getting inside as a result
of misuse by the user.
Precaution:
Follow the steps below to keep the camera waterproof.
Step 1: Apply silicon grease (included).
Take out the o-ring and use your
fingers to gently rub on a thin layer
of silicon grease onto the surface of
the o-ring. The silicon grease needs
to be applied on the o-ring evenly.