Filter
Top Products
42
OO
OO
tt
tt
hh
hh
ee
ee
rr
rr
ss
ss
OO
OO
tt
tt
hh
hh
ee
ee
rr
rr
ss
ss
Warning/Alarm Indications
If any one of the following indications lights up or
flashes, please check the condition of the Camera
Recorder.
BLANK: Blank Search -34-
DEW DETECT, EJECT TAPE:
Condensation has occurred. -47-
CHECK REC TAB
:
The accidental erasure prevention
slider on the inserted Cassette is open
(that is, set to [SAVE]).
You are about to do audio dubbing on
the unrecorded (blank) portion of the
tape.
No Cassette is inserted. -14-
: The Battery is low. Recharge it. -12-
: The video heads are dirty. -47-
END: The tape came to end during recording.
CHECK REMOTE MODE:
Wrong Remote Controller Mode has
been selected. -11-
INCOMPATIBLE DATA:
You are attempting to play back a tape section
that has been recorded with a different TV
system.
CANNOT REC LP-MODE:
Because the original recording was done in LP
Mode, audio dubbing cannot be performed.
INCOMPATIBLE TAPE:
This Cassette is incompatible.
PUSH THE RESET BUTTON:
Mechanism Irregular is detected. Press the
[RESET] Button (-8-). This may solve the
problem.
NEED TO BE SERVICED:
It is a malfunction.
INCOMPATIBLE DATA:
Because the medium is protected by a copy
guard, images cannot be recorded correctly.
Notes and Hints
$ Concerning the Power Supply
OWhen the Camera Recorder is used for a long time,
the Camera body becomes warm, but this is not a
malfunction.
OIf the [CHARGE] Lamp does not light up although
the Battery is attached to the AC Adapter, detach
the Battery and reattach it.
OBattery CGP-D110 and CGP-D105 cannot be
charged with this AC Adapter.
$ Inserting/Removing the Cassette
OIn the case of using a previously recorded Cassette,
you can use the Camera Search Function to find
the position where you want to continue recording.
OIf a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
OWhen inserting the cassette, make sure it faces in
the right direction and then push it in until it stops.
$ Alarm Sounds
When [BEEP SOUND] on the [OTHER FUNCTIONS]
Sub-Menu on the [CAMERA FUNCTIONS] Main-
Menu is set to [ON], confirmation/alarm beeps are
issued as follows.
1 Beep
OWhen you start recording
OWhen you switch the [OFF/ON] Switch from [OFF]
to [ON]
2 Beeps
OWhen you pause recording
2 Beeps a4
OIf you perform a wrong operation before or during
recording
$ Recording
OBefore turning on the power, remove the Lens Cap.
If the Lens Cap is still attached when the power is
turned [ON], Automatic White Balance Adjustment
(-27-) may not function correctly.
$ Recording Check
OFor Recording Check, the recording speed mode
(SP/LP) must be the same as the mode used for
the recording. If different, playback images will be
distorted.
$ Camera Search
OIn Camera Search Mode, images may contain
mosaic-pattern noise. This is a phenomenon that is
characteristic of digital video and not a malfunction.
OIf the recording speed modes (SP/LP) of previous
recording and new recording are different, playback
images may be distorted.
$ Photoshot
OPhotoshot Recording results in slightly inferior
image quality.