Filter
Top Products
102
Setup menu list (continued)
RECORD SETUP screen
Item
Display
mode
Q.MENU Description of settings
REC FORMAT CAMERA Selects the recording format.
PH 1080/60i
PH 1080/30P
PH 1080/24P
PH 720/60P
PH 720/30P
PH 720/24P
HA 1080/60i
HG 1080/60i
HE 1080/60i
PH 1080/24P and PH 720/24P represent native recording.
You cannot change the format during interval recording.
•
•
PREREC
MODE
CAMERA Sets PRE RECORDING to ON or OFF. (Page 46)
ON
OFF
TCG is set to FREE RUN.
Cannot be set during INTERVAL REC.
•
•
TIME STAMP CAMERA Specifies whether date and time information is superimposed over
recorded images.
ON:
Superimposes date and time information on the image.
OFF: Does not superimpose date and time information on the
image.
INTERVAL REC CAMERA Enables frame-by-frame recording at specified intervals to create short
videos of scenes with slow movement over long periods of time. Single
frames are recorded at the specified interval, with 24 frames equaling 1
second of video.
OFF, 1 SECOND, 10 SECONDS, 30 SECONDS, 1 MINUTE,
2 MINUTES
When INTERVAL REC is enabled, the following setting items
automatically change as follows.
REC FORMAT: PH 1080/24P, TC MODE: NDF
•
TC MODE CAMERA Selects the correction mode of the internal time code generator when
the time code of the internal time code generator is recorded.
DF: Uses the drop frame mode.
NDF: Uses the non-drop frame mode.
TC MODE is automatically set to NDF when you set recording frame
rate of recording format to 24P.
•
TCG CAMERA Sets the mode in which you advance the internal time code generator.
FREE RUN: The time code is advanced regardless of the operation
mode.
A slight time error may occur when switching to PB mode if the frame
rate is set to 24P.
REC RUN: The time code is advanced only when recording.
TC PRESET CAMERA Sets the initial time code.
YES
NO
Set the frame value to 0 or a multiple of 4 when you set recording
frame rate of recording format to 24P. If any other value is set, the
recorded time code will mis-match.
•
UB PRESET CAMERA Sets the user information.
YES
NO
indicates the factory setting.
: Can also be configured in Quick Menu. (Page 96)