Filter
Top Products
43
Viewfinder screen status displays
Display modes and setting
change messages
The display of messages advising the user of what
changes have been made to the settings and what the
adjustment results are can be turned off for some or
all of the items displayed.
<Note>
The message displays also depend on the status of
other menu settings. For instance, even when “1 (no
display)” is set as the filter selection, the filter
selection will be displayed when FILTER is set to “ON”
on the VF INDICATOR screen.
±
: Message is to be displayed.
t
: Message is not to be
displayed.
Setting change/adjustment result messages and display modes
Situation in which message is displayed Message
Display mode
setting
123
t t ±
When the filter selection has been changed Filter: n (n=1, 2, 3, 4), m (m=A, B, C, D)
t t ±
When the gain setting has been changed GAIN: n dB
(n= –6, –3, 0, 3, 6, 9, 12, 18, 24, 30)
t t ±
When the WHITE BAL switch setting has been
changed
WHITE: n (n=ACH, BCH, PRESET)
t ± ±
When the OUTPUT/AUTO KNEE switch has
been set to AUTO KNEE or OFF
<Note>
This display is shown for about 3 seconds
immediately after the unit’s power has been
switched on.
AUTO KNEE: ON (or OFF)
t ± ±
When the shutter speed/mode setting has been
changed
SS: 1/100 (or 1/120, 1/250, 1/500, 1/1000, 1/2000,
S.SCAN)
t ± ±
When the white balance (AWB) has been
adjusted
Example) AWB: OK
For details, refer to “Adjusting the white balance”
(pages 47 to 50).
t ± ±
When the black balance (ABB) has been
adjusted
Example) ABB: OK
For details, refer to “Adjusting the black balance” (page
51).