Filter
Top Products
91
Setting menu screens
(CAM MAIN MENU 3)
GENLOCK/IRIS screen
The genlock and iris control settings are performed on
this screen.
Item
Variable
range
Remarks
VF
display
H PHASE
COARSE
0
:
7
:
15
USER
ENG
For coarsely adjusting the
H phase during genlock.
H PHASE FINE 0
:
32
:
64
USER
ENG
For finely adjusting the H
phase during genlock.
A. IRIS LEVEL 0
:
82
:
100
USER
ENG
For setting the auto iris
target level.
The brightness (iris) is
controlled using this value.
The higher the value
selected, the higher the
brightness.
A. IRIS
PEAK/AVE
0
:
16
:
100
USER
ENG
For setting the ratio
between the auto iris peak
and average value.
The closer the setting is to
0, the greater the
tendency toward average
control; conversely, the
closer the setting is to
100, the greater the
tendency toward peak
control.
A. IRIS MODE NORM1
NORM2
CENTR
USER
ENG
For selecting the auto iris
mode.
NORM1
:
The light is measured for
the entire screen (except
for the edges).
NORM2
:
The light is measured for
the entire screen (except
for the top part).
CENTR
:
The light is measured in
the center area of the
screen only.
S. IRIS LEVEL 0
:
100
USER
ENG
For setting the super iris
target level.
(Backlight compensation
mode)
The underlining in the variable range column indicates the setting in the preset mode.
LENS ADJ screen
The lens adjustments are performed on this screen.
Item
Variable
range
Remarks
F2.8 ADJ ON
OFF
VF
display
ENG For outputting the voltage
output only when ON is
selected as this item’s
setting.
F16 ADJ ON
OFF
ENG For outputting the voltage
output only when ON is
selected as this item’s
setting.
<Note>
When using a lens which enables the open limit and close limit of
the lens aperture to be adjusted, set “F2.8ADJ” or “F16ADJ” to ON,
and repeatedly adjust so that the lens aperture will be set to “F2.8”
or “F16.”
(This adjustment need not be performed if the lens does not have
this adjustment function.)