Filter
Top Products
Removal lever
Battery pack
22
Power supply
Using the Anton/Bauer battery pack
A battery pack or an AC power source can be used as
this unit’s power supply.
To use the battery pack, there is a choice of
makes of batteries below, namely:
OAnton/Bauer
OIDX
OSony
<Note>
Batteries of other makes can also be supported by
changing the setting menu but no guarantees are
made for the system when they are actually used with
this unit.
Before using the battery pack, recharge the battery
using the battery charger.
(For details on the recharging method, refer to the
operating instructions of the battery concerned.)
<Note>
An intelligent battery system and ultra light system are
supported.
The remaining battery charge displayed inside the
viewfinder is usually shown as a percentage of the full
charge, but when the battery charge is nearly
completely dissipated, the percentage display is
replaced with a voltage display.
1
Attach the battery pack.
Insert the pack in the direction shown by the
arrows, and then slide it into position.
2
To detach the battery, pull the battery mount
removal lever all the way down, and slide the
battery pack in the direction shown by the arrow.