Filter
Top Products
83
7
Chapter 7 Menu description tables
7-3-7 ADDITIONAL DTL
Item
Variable
range
Remarks
KNEE APE LVL OFF
1
2
:
5
For performing the KNEE APE LEVEL setting.
CHROMA DTL OFF
0
:
5
For performing the CHROMA DTL setting.
The chroma edge is detected and placed on
the Y signal to bolster H.DTL. The higher the
number, the greater the correction.
DTL GAIN(+) –31
:
+00
:
+31
For changing the H.DTL “+” direction level.
DTL GAIN(–) –31
:
+10
:
+31
For changing the H.DTL “–” (down) direction
level.
DTL CLIP 00
:
63
For changing the DTL signal “+” direction clip.
DTL SOURCE (R+G)/2
(G+B)/2
2G+R+B /4
(3G+R)/4
R
G
For setting the signal source of the DTL signal
components.
H.DTL LINE MIX 0H
1H
2H
For setting the scanning lines for generating
the H.DTL signal.
CORNER DTL ON
OFF
For selecting ON or OFF for the mode in
which the resolution is improved in the
corners of the screen.
7-3-8 SKIN TONE DTL
Item
Variable
range
Remarks
SKIN TONE DTL ON
OFF
For selecting ON or OFF for the skin tone
DTL.
SKIN TONE ZEBRA ON
OFF
For selecting ON or OFF for ZEBRA in the
SKIN TONE range.
SKIN DTL CORING 0
:
5
:
7
For setting the SKIN TONE DTL coring effect.
Y MAX 000
:
190
:
255
For setting the maximum luminance signal
value for applying the SKIN TONE effect.
Y MIN 000
:
010
:
255
For setting the minimum luminance signal
value for applying the SKIN TONE effect.
I CENTER 000
:
030
:
255
For setting the center position on the I axis
(setting the area to which the SKIN TONE
effect is to be applied).
I WIDTH 000
:
035
:
255
For setting the width of the area to which the
SKIN TONE effect is to be applied on the I
axis centered on the I CENTER.
Q WIDTH 000
:
010
:
255
For setting the width of the area to which the
SKIN TONE effect is to be applied on the Q
axis centered on the I CENTER.
Q PHASE –31
:
+00
:
+31
For setting the phase of the area to which the
SKIN TONE effect is to be applied as
referenced to the Q axis.
R-Y
B-Y
Q-WIDTH
I-WIDTH
Q-PHASE
I-CENTER
Y
Y-MAX
Y-MIN
0
=SKIN TONE AREA
– direction
+ direction
The underlining in the variable range column indicates the setting in the preset mode.