Filter
Top Products
-45-
When an option card is added, only the composite
output and Y/C output will be reproduced in nega-
tive image.
Note
(G-R): To increase or decrease the intermediate
color between green and cyan
(G-B): To increase or decrease yellowish green
(B-R): To increase or decrease the intermediate
color between blue and cyan
(B-G): To increase or decrease purple
%8 Gamma Correction Level Setting
[Gamma: 0.35 - 0.55]
Gamma correction level can be set.
%9 Knee Compensation Level Setting [Knee Point:
88% - 98%/Dynamic]
88% - 98%: The level of video signals subject to
knee compensation (knee point) can be set.
Dynamic: Knee compensation level is automatically
adjusted according to the scene.
^0 White Clip Level Setting [White Clip:
95% - 110%]
The peak level of video signals to be white-clipped
can be set.
^1 Flare Correction Level Setting [Flare R/G/B:
0 - 100]
Flare correction level can be adjusted.
* Flare correction level has already been adjusted
prior to shipment from the factory.
^2 Black Stretch Setting [Black Stretch: ON/OFF]
Black stretch to correct the suppression of black
portions at low luminance can be set to ON or OFF.
^3 PC Control Access Speed Setting [Baud Rate:
1 200bps/2 400bps/4 800bps/9 600bps]
This setting is to select a communication speed in
controlling the camera from the computer.
^4 Negative/Positive Selection [Nega/Posi:
Posi/Nega]
Posi: Normal image
Nega: Image is shown reversed in darkness and
color.
^5 Aspect Ratio Selection [Aspect Ratio: 16:9/4:3]
^6 Fan ON/OFF [Fan: ON/OFF]
The cooling fan can be turned off if fan noise is dis-
turbing in a studio, for example.