Filter
Top Products
Operating Instructions
107[For assistance, please call: 1-800-272-7033]
2.24 Controlling External Output Terminal
The digital output terminal allows you to control the external devices. You can
change the initial status of the output signal.
1. Click [External Output] on the Setup page.
2. Click [Save] when finished.
• Clicking [Cancel] cancels your settings without saving changes.
• New settings are saved.
• When finished, "Success!" is displayed.
3. Click [Go to External Output Control page].
• The External Output Control page is displayed.
Setting Description
External Device
Control Output
• If you check [Open], the internal transistor turns off and the
external output terminal gets high impedance (open
collector) when the camera powers up. If you check [Short
to GND], the internal transistor turns on and is electrically
short-circuited to GND pin when the camera powers up.
The external output terminal gets low impedance (0 V).
Button name
modification
• You can change the output control button names on the
operation bar. You can name the button depending on your
external devices.