Filter
Top Products
Operating Instructions
42
Setting Description
Allow Access from
the Internet
(Automatic Setup
Only)
• Allow Access from the Internet setting automatically
configures the router's Port Forwarding setting (some
routers call it "Address Translation", "Static IP
Masquerade", "Virtual Server" or "Port Mapping"). To
enable Internet access to the camera, check [Yes]. In this
case, the camera automatically searches the unused port
number on your network in the order from 50000 to 50050.
To disable Internet access to the camera, check [No].
Network
Configuration from
Setup Program
(Static/DHCP Only)
• If you prohibit the Setup Program from changing the
network settings, clear the check box.
Port Number
(Static/DHCP Only)
• The port number is 80 by default. When you use multiple
cameras with a router on your network, each camera must
be assigned its own port number (see page
27 "1.9
Connecting the Camera to a Router Not Supporting
UPnP™ (IPv4 Only)" in the Installation/Troubleshooting).
• Do not set the following port numbers.
E.g., FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
POP3: 110, HTTPS: 443, ICQ: 4000 and IRC: 6661—
6667.
• Enter only the number (1—65535).
• Some ISPs do not allow you to use port 80. Ask your ISP
or network administrator about the accessible port number
over the Internet.
• IP address
• Subnet Mask
(Static Only)
• If your ISP or network administrator specifies the IP
address and subnet mask, enter them in each data field.
• If you use the camera on the LAN, set the IP address in the
same class as your PC (see page
132).
• Set 4 digits (0—255) and 3 periods such as
"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
not available.
Host Name
(DHCP Only)
• If your ISP uses the DHCP function which automatically
assigns the IP address to the camera, enter the ISP-
assigned host name. (Host name may be used as an
authentication.)
• Enter ASCII characters for the host name (see page 140).
But [Space], ["], ['], [&], [<] and [>] are not available.