Panasonic BL-VP104W Security Camera User Manual


 
Note
The camera will restart after the connection setting is changed.
When using the self-signed certificate:
If the camera is accessed using the HTTPS protocol for the first time, the warning window will be
displayed. In this case, follow the instructions of the wizard to install the self-signed certificate.
(®page 119)
When using the server certificate:
In advance, install the root certificate and intermediate certificate on the browser in use. Follow the
instructions of CA for how to obtain and install these certificates.
When the camera is accessed using the HTTPS protocol, the refresh interval and frame rate of images
may be lower.
When the camera is accessed using the HTTPS protocol, it may take time to display images.
When the camera is accessed using the HTTPS protocol, the images may be distorted or audio may
be interrupted.
The maximum number of concurrent access user varies depending on the maximum image size and
transmission format.
[FTP access to camera]
Select “Allow” or “Forbid” to determine whether to allow or forbid the FTP access to camera.
Default: Forbid
[Bandwidth control(bit rate)]
Select the total bit rate for data transmission from the following.
Unlimited/ 64kbps/ 128kbps/ 256kbps/ 384kbps/ 512kbps/ 768kbps/ 1024kbps/ 2048kbps/ 4096kbps/
8192kbps
Default: Unlimited
Note
When selecting “64kbps”, select “Off” for “Audio transmission/reception” on the [Audio] tab.
(®page 72)
Select “128kbps” or a faster rate to carry out the live transmission of JPEG images and the FTP periodic
image transmission simultaneously.
When “Bandwidth control(bit rate)” is set low, taking a picture using the snap shot button may not
function depending on the use environment. In this case, select “QVGA” for “Image capture size” of
“JPEG” on the [JPEG/H.264] tab or set “Image quality setting” of “JPEG” lower.
[Easy IP Setup accommodate period]
Select “20min” or “Unlimited” to determine how long the network setting operation using the Panasonic “IP
Setting Software” can be allowed.
20min: The camera and the network setting operation using the Panasonic “IP Setting Software” are
allowed for 20 minutes since the camera starts up.
Unlimited: The camera and the network setting operation using the Panasonic “IP Setting Software” are
allowed without time limitation.
Default: 20min
Note
Refer to the network administrator for the addresses of each server.
The port forwarding function changes a global IP address to a private IP address, and “Static IP
masquerade” and “Network Address Translation (NAT)” have this function. This function is to be set in
a router.
110 Operating Instructions
15 Configuring the network settings [Network]