Filter
Top Products
86
VQT1C63
Connecting to other equipment
• Do not use any other USB connection
cables except the supplied one.
• While [ACCESS] is being displayed,
do not disconnect the USB connection
cable.
• Data transmission takes time when a
card contains a large number of pictures.
• Motion image fi les in the built-in memory
or on a card in this unit may not play
properly on a computer, so upload them
to your computer for playback.
• If the remaining battery power is
exhausted during communication, the
recorded data may be damaged. When
you connect the camera to the PC, use a
battery with suffi cient battery power (P24)
or the AC adaptor (DMW-AC6; optional).
• If the remaining battery power becomes
low while the camera and the PC are
communicating, the status indicator
blinks and the alarm beeps. In this case,
stop the communication at once on the
PC.
• When connecting the camera to a
Windows 2000 OS PC with the USB
connection cable, do not replace the
card while the camera and the PC
are connected. The information on
the card may be damaged. Before
changing cards, make sure you do
the necessary steps to safely remove
hardware (double-click the icon in the
task bar in Windows).
• Pictures edited or rotated with a PC may
be displayed in black in playback mode
(P34), multi playback (P67) and calendar
playback (P68).
• Refer to the operating instructions of the
PC, too.
• If a card is not inserted when the camera
is connected to the PC, you can edit or
access the picture data on the built-in
memory. If a card is inserted, you can
edit or access the picture data on it.
• You cannot switch between the built-in
memory and the card while the camera is
connected to the PC. When you want to
switch between the built-in memory and
the card, disconnect the USB connection
cable, insert (or remove) the card and
then connect the USB connection cable
to the PC again.
• When you change the mode dial to print
mode [ ] with the camera connected
to the PC, [PLEASE RE-CONNECT THE
PRINTER.] appears on the camera’s
LCD monitor. Before reconnecting the
camera to a printer, change the mode
from [ ] to another one and make sure
that data transmission is not in progress.
([ACCESS] appears on the camera’s
LCD monitor while data transmission is in
progress.)