Filter
Top Products
96
VQT1C63
Others
Message Display
Confi rmation messages or error messages will be displayed on the screen in some cases.
The major messages are described below as examples.
[CURRENT BATTERY TYPE SETTING:
OXYRIDE]/[CURRENT BATTERY TYPE
SETTING: ALKALINE/Ni-MH]
This message is displayed the fi rst time
you insert batteries and when the batteries
are exhausted and you replace them. If the
battery type being used is different from
the one indicated in the message, change
the battery type in [BATTERY TYPE] in the
[SETUP] menu. (P21)
[THIS MEMORY CARD IS LOCKED]
Cancel the card lock. (P16, 79)
[NO VALID PICTURE TO PLAY]
Play back after recording or after inserting
a card with a recorded picture.
[THIS PICTURE IS PROTECTED]
After canceling the protect setting (P79),
you can delete or overwrite the picture.
[THIS PICTURE CANNOT BE DELETED]/
[SOME PICTURES CANNOT BE
DELETED]
The pictures not based on the DCF
standard cannot be deleted.
To delete this kind of picture, fi rst save
your data to your computer, then use this
unit to reformat the card. (P83)
[NO ADDITIONAL DELETE SELECTIONS
CAN BE MADE]
You have selected more than the allowed
number of items in multi delete or the
MULTI setting in [DATE STAMP]. Repeat
the procedure as necessary.
You have placed more than 999 pictures in
your favorites list.
[CANNOT BE SET ON THIS PICTURE]/
[CANNOT BE SET ON SOME PICTURES]
The DPOF setting cannot be set to the
following pictures.
• Pictures not based on the DCF.
[NOT ENOUGH SPACE ON BUILT-IN
MEMORY]/[NOT ENOUGH MEMORY ON
THE CARD]
There is no space left on the built-in
memory or the card.
• When you copy pictures from the built-
in memory to the card (batch copy), the
pictures are copied until the capacity of
the card becomes full.
[SOME PICTURES CANNOT BE
COPIED]/[COPY COULD NOT BE
COMPLETED]
The following pictures cannot be copied.
• When a picture with the same name as
the picture to be copied exists in the copy
destination.
• Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR FORMAT
BUILT-IN MEMORY?]
This message will be displayed when you
format the built-in memory on the PC or
remove the battery without turning the
camera off. Format the built-in memory of
the camera again. (P83) The data on the
built-in memory will be deleted.