Filter
Top Products
Advanced (Recording pictures)
- 82 -
When [AUTO REGISTRATION] is set to [ON] in step 3 of “Change the information for a
registered person” (P81) while [FACE RECOG.] in the [REC] Mode menu is set to [ON],
the registration screen will display automatically after taking a picture of a face that has a
high number of appearances.
•
Registration screen is displayed after approximately 3 pictures. (It is not counted when
[BURST], [AUDIO REC.] and Auto Bracket is set.)
•It may be extremely hard to recognize only with [AUTO REGISTRATION], so register the face
images with [FACE RECOG.] in the [REC] Mode menu beforehand.
∫ Registering from the automatic registration screen
1 Press 3 to select [YES] and then press [MENU/SET].
•
If there are no registerd persons, proceed to step 3.
• Selection screen is displayed again when [NO] is selected, and
when [YES] is selected with
3, [AUTO REGISTRATION] will be
set to [OFF].
2 Press 3/4 to select [NEW PERSON] or
[ADDITIONAL IMAGE] and then press [MENU/SET].
•
After additionally registering or replacing a face image, the screen returns automatically to
the recording screen.
3 Perform the operation in Step 5 and following in “Registering face image of new
person”.
Note
•
If the registration screen will not display, it may display easier by recording in the same
conditions or with the same expressions.
•If a face is not recognized even though it is registered, it will make the recognition easier by
registering the person again using the [FACE RECOG.] in the [REC] Mode menu in that
environment.
•If the registration screen is displayed for the person that is already registered, it will make the
recognition easier by additionally registering.
•It may make recognition harder when a picture recorded with flash is registered.
Auto Registration
Item Description of settings
[NEW PERSON]
•A list of registered people is displayed when there are 6 people
already registered. Select the person to be replaced.
[ADDITIONAL IMAGE]
To additionally register a face image for a registered person.
Press 3/4/2/1 to select the person to whom you wish
add the picture, and then press [MENU/SET].
•
If 3 images have already been registered, the picture
replacement screen will appear. In this case, select the picture
you wish to replace.