Filter
Top Products
Preparation
14
VQT0Q40
Inserting/Removing the Battery
• Check that the camera is turned off and
that the lens is retracted.
• Close the flash.
1 Slide the card/battery door to
open it.
• Please be sure to use genuine
Panasonic batteries (CGA-S002E).
2 Insert:
Insert the charged battery until it
clicks.
Remove:
Slide the lock 1 to remove the
battery.
3 1 Close the card/battery door.
2 Slide the card/battery door to
the end and then close it firmly.
• If you will not be using the camera for a
long time, remove the battery.
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (The storing time may be
shorter if the battery is not charged
sufficiently.)
If more than 3 months has passed, the
clock setting will be lost. In this case, set
the clock again. (P21)
• Do not remove the card and the battery
while the card is being accessed. The
data on the card may be damaged.
(P16)
• Do not remove the battery with the
camera turned on since the settings on
the camera may not be stored properly.
• The supplied battery is designed only
for the camera. Do not use it with any
other equipment.
VQT0Q40ENG.book 14 ページ ２００５年２月１６日 水曜日 午後２時４７分