121
VQT1T27
Connecting to other equipment
• Ensure that the screw parts of the lens adaptor and the filter are properly tightened.
Note
•
Do not attach multiple filters at the same time.
• If the filter is tightened too much, you may not be able to remove it. Do not tighten it too much.
• If the filter is dropped, it may be destroyed. Be careful not to drop it when attaching it to the
camera.
• Be careful not to get a fingerprint, dirt, etc., on the filter when it is attached, otherwise the focus
may be adjusted to the lens, resulting in the subject being out of focus.
• Refer to the instructions for each filter for details.
• Turn off the camera when removing the filter.
• MCu“Multi-coated”
ND
u“Neutral Density”
Using the External Flash (optional)
After attaching the external flash, the effective range will be increased when compared to
the camera’s built in flash.
Preparations: Turn off the camera and close the built-in flash.
∫ Using the dedicated flash (DMW-FL360; optional)
Attach the dedicated flash to the hot
shoe A and then turn on the camera and
the dedicated flash.
• Be sure to firmly secure to dedicated flash with the
lock ring B.
Press 1[‰].
1
2
P.PC_DMC-LX3_eng.book 121 ページ 2008年7月8日 火曜日 午後10時13分