Panasonic DMC-TZ35 Camera Flash User Manual


 
VQT4P34
Others
Usage cautions and notes
- 161 -
Charging the battery
The time required for charging varies depending on conditions of battery usage. Charging takes
longer at high or low temperatures and when the battery has not been used in some time.
Battery will be warm during charging and for some time thereafter.
Battery will run out if not used for long periods of time, even after being charged.
Do not leave any metal items (such as clips) near the contact areas of the power plug.
Otherwise, a fire and/or electric shocks may be caused by short-circuiting or the resulting heat
generated.
Frequently charging up battery is not recommended.
(Frequently charging battery reduces maximum usage time and can cause battery to expand.)
If available battery power is significantly reduced, battery is reaching end of lifespan. Please
purchase a new battery.
When charging:
Wipe dirt from the battery terminal with a dry cloth.
Keep at least 1 m (3.3 feet) away from AM radio (may cause radio interference).
Do not use a damaged or dented battery (especially connectors), e.g. by dropping (can cause
faults).
AC adaptor (supplied)
Keep at least 1 m (3.3 feet) away from AM radio (may cause radio interference).
The AC adaptor (supplied) may generate whirring sounds when it is being used. This is not a
malfunction.
After use, be sure to disconnect the power supply device from the electrical outlet. (A very small
amount of current is consumed if it is left connected.)
Lens
If lens is dirty:
Images may appear slightly white if lens is dirty (fingerprints, etc.). Turn the camera on, hold the
extracted lens barrel with your fingers, and gently wipe the lens surface with a soft, dry cloth.
Do not leave the lens exposed to direct sunlight.
Do not touch the lens barrier, as this may damage the lens. Be careful when removing camera from
bag, etc.
When using a tripod or unipod
Do not apply excessive force or tighten screws when they are crooked. (This may damage the
camera, screw hole, or label.)
Ensure that the tripod is stable. (Refer to the tripod instructions.)
You may not be able to remove the card or the battery when using a tripod or unipod.