![](http://pdfasset.owneriq.net/8/b9/8b905bfc-1818-4d9f-9036-4881c6a10799/8b905bfc-1818-4d9f-9036-4881c6a10799-bg22.png)
- 34 -
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick Start Standby Mode about 70% of the power used in recording pause mode
is being consumed, so the recording time will be reduced.
≥
/
Quick Start will not work if there is no SD card inserted.
≥
Quick Start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is no
SD card inserted.
1 Select the menu.
2 Close the LCD monitor.
The status indicator A flashes green and the unit goes into
Quick Start Standby Mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put
into recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes elapsed
jmode is set to
≥ Depending on the recording conditions and menu settings, time for Quick Start may be longer
than 0.6 seconds.
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY (BATT)]
(l 33)/[ECONOMY (AC)] (l 33), close the LCD monitor once and open it again.
≥ Turn the unit off using the power button.
Touch screen operation, starting and stopping of recording and unit on/off can be confirmed with this
sound.
When [OFF] is selected, the sound is not output at the start/end of recording, etc.
2 Beeps for 4 times
When an error occurs. Check the sentence displayed on the screen. (l 171)
[QUICK START]
: [SETUP] # [QUICK START] # [ON]
[ALERT SOUND]
: [SETUP] # [ALERT SOUND] # desired setting
(Volume low)/ (Volume high)/[OFF]
HC-V520
HC-V510
HC-V520M
MENU
MENU