Filter
Top Products
Others
141
VQT1J42
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ The unit cannot be operated unless you open the LCD monitor or
extend the viewfinder.
≥ Press the RESET button. (l 145) If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about 1 minute
and then reconnect the battery or AC adaptor. Then about 1 minute
later, turn on the power again. (Conducting the above operation
when the access lamp is on may destroy the data on the disc or SD
card.)
The remote control does
not function.
≥ Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 22)
The message “DISC
DOOR OPENED.”
appears although the
disc cover is closed.
≥ This message may appear if the battery is removed or the AC
adaptor is disconnected while removing a disc or before the power
to the unit fully turns off.
# Open the disc cover with the DISC EJECT lever and then close it
again.
The DISC EJECT lever
does not work.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is connected to
the computer.
# Disconnect the USB cable.
The screen has changed
suddenly.
≥ Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting a disc or an
SD card in recording mode, the unit is automatically set to the
demonstration mode for introducing its functions. Normally this
should be set to [OFF]. Press the MENU button, then select
[SETUP] # [DEMO MODE] # [OFF] and press the cursor
button.
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥ If you set [SETUP] > [DISPLAY] > [OFF], all indications other
than warnings and date are not displayed.
VQT1J42ENG.book 141 ページ ２００７年７月２０日 金曜日 午前１０時３６分