Filter
Top Products
12
VQT1Z09
Quick Guide
w Charging the battery
Connect the AC cable to the AC adaptor and
the AC outlet.
Insert the battery into the AC adaptor by
aligning the arrows.
w Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
Insert the battery until it clicks and locks.
w Inserting/removing an SD card
1) Open the LCD monitor.
p Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever .
3) Insert/remove the SD card.
p Face the label side in the direction shown in
the illustration and press it straight in as far as
it will go.
p Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
p Securely close it until it clicks.
w How to turn on the power
Turn on the power by changing the mode to ,
or while pressing the lock release
button .
p
To turn off the power, change the mode to
OFF
.
Access lamp [ACCESS]
p When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
Charging lamp
[CHARGE]
Lights up:
Charging
Goes off:
Charging completed
OPEN
p Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
p Align with .
p Status indicator
HDC-TM300
p Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
p Align with .
p Status indicator
OFF
HDC-HS300