Filter
Top Products
8
SQT0243 (ENG)
∫Attaching the Lens Hood
(Supplied Accessory)
≥ Before attaching the lens
hood, make sure to remove
the lens cap. The lens hood
cannot be attached unless
you remove the lens cap.
1 Rotate the decoration ring C in the
direction of the arrow to remove it.
2 Align the mounting index D on the lens
hood with the mark on the tip of the lens.
3 Rotate the lens hood in the direction of
the arrow until it clicks into place, and
align the stop position
E on the lens
hood with the index on the tip of the lens.
Note
≥ When using this lens and the flash to record a
subject very close to the camera, it is possible that
a darker shadowed area may appear in the lower
portion of the picture. This situation is not a
malfunction and is caused when the flash is
partially blocked by the lens. This situation may be
worsened when the lens hood is used.
≥ When using the AF assist lamp in the dark, detach
the lens hood.
≥ Make sure to remove the lens hood cap when
recording an image.
23
SQT0243_ENG_SPA.book 8 ページ ２０１４年４月１１日 金曜日 午前９時３３分