Filter
Top Products
9
(ENG) SQT0243
∫Attaching the decoration ring
≥ Before attaching the decoration ring, make
sure to remove the lens cap.
1 Align the mounting position G on the
decoration ring with a position
approximately 90x away from the lens
fitting mark
F to fit the decoration ring
into place.
2 Rotate the decoration ring in the
direction of the arrow to align the
mounting position
G on the decoration
ring with the lens fitting mark
F.
∫Attaching Filters
≥ Vignetting may occur if using 2 or more
MC protectors (optional: DMW-LMC46), PL filters
(optional: DMW-LPL46) or ND filters (optional:
DMW-LND46), or if using thick protectors and/or
filters.
≥ The filter may become impossible to remove if
excessively tightened, so please refrain from
tightening it too strongly.
≥ It is possible to attach the lens cap with the filter
already attached.
≥ When the lens hood is attached to this lens, you
cannot attach a filter to it.
≥ You cannot attach a conversion lens or adaptor to
this lens. A filter may be used, but attaching any
other element may cause damage to the lens.
12
SQT0243_ENG_SPA.book 9 ページ ２０１４年４月１１日 金曜日 午前９時３３分