Panasonic DMC-LZ5 Digital Camera User Manual


 
Preparation
17
VQT0U87
2 Insert:
Insert the card fully until it clicks
and it is locked.
Remove:
Push the card until it clicks, then
pull the card out upright.
Check the direction of the card.
Do not touch the connection terminals
on the back side of the card.
The card may be damaged if it is not
fully inserted.
3 1 Close the card door.
2 Slide the card door to the end
and then close it firmly.
If the card door cannot be completely
closed, remove the card and insert it
again.
The card and the data may be damaged
if it is inserted or removed while the
camera is on.
We recommend using Panasonic’s SD
Memory Card.
About the Built-in
Memory/the Card
Built-in Memory [ ]
You can record or play back pictures on
the built-in memory when you are not
using a card.
The built-in memory capacity is about
14 MB.
Picture size is fixed to QVGA
(320k240 pixels) when recording
motion pictures to the built-in memory.
(P55)
Card [ ]
You can record or play back pictures on
a card.
(The built-in memory cannot be used
when a card is inserted.)
Access to the built-in memory or the
card
The access indication lights red when
pictures are being recorded on the built-in
memory (or the card).
Do not do the following when the access
indication lights, pictures are being read or
deleted or the built-in memory (or the
card) is being formatted (P78).
Turn the camera off.
Remove the batteries or the card (if
used).
Shake or impact the camera.
Disconnect the AC adaptor (DMW-AC6;
optional). (when using the AC adaptor)
The card or the data may be damaged and
the camera may not operate normally.
VQT0U87ENG.book 17 ページ 2005年12月27日 火曜日 午後7時12分